"
Thank you Ground_0, I purchased two new units off eBay and am working to set them up now for purposes of Internet firewall, routing and site-to-site WireGuard VPN between two locations. I have installed OPNsense onto an ORICO 128GB NVMe M.2 drive from Amazon. So far so good.
Regarding the port identification:
OPNsense Device → Label on Unit
igb0 → mgmt0
igb1 → mgmt1
ix0 → lan0
ix1 → wan0
ix2 → lan1
ix3 → wan1
Edit: I now see you listed the port mapping in your initial post, I just glazed over them. Thanks again!
Regarding the port identification:
OPNsense Device → Label on Unit
igb0 → mgmt0
igb1 → mgmt1
ix0 → lan0
ix1 → wan0
ix2 → lan1
ix3 → wan1
Edit: I now see you listed the port mapping in your initial post, I just glazed over them. Thanks again!
