Messages

At OPNsense for e.g.. my interface info is the following:

Media   10Gbase-T <full-duplex>

Media (Raw)   Ethernet autoselect (10Gbase-T <full-duplex>)

Line Rate   10.00 Gbit/s

Checked out everything... all my NIC and everything should be in the right duplex, even checked the port's LEDs, and they are all doing green... However, now, even on LAN... it's still somehow max out at 100Mb... Recent Speedtest for e.g. is 94,6mb download and upload...

Hello OPNsense Community!

I'm posting here, for help since I couldn't really find my answers... My Problem is the following:

Randomly, my AP's speed suddenly went down really bad.. I've read some similar topics here, but there, I couldn't really find the solution I've been looking for, since many post said like "it's obviously the AP's problem, not OPNsense related" and so on... I could accept it, but the fact, that it was good before, and had a decent speed, and now it's slow...

Anyways, too much talking... I'm new, to posting here, but I'll try to write as many infos about my setup, that I could think of, that can help here...+ I'll upload here my LAN speed test and my Speedtest on connected wireless to my AP..

I'm connected to my AP with 6Ghz, and relatively not far away.. there are only 1 SSID not near here, so that can't be an issue suddenly..

My AP's info is the following:

TP-Link Deco XE200

-it's WIFI 6E
-has 10GBs eth port on it
-Can do the following speed
   2,5GHZ - 1148 Mbps
   5GHZ - 4804 Mbps
   6GHZ - 4804 Mbps
So in total, around 10,8 Gpbs

I'll link it's page here: ( https://www.tp-link.com/hu/home-networking/deco/deco-xe200/ )


My Speedtest on LAN was the following:

Download - 1504Mbps
Upload - 290Mbps

My Speedtest on the Acces Point at 6Ghz was the following:

Download - 94Mbps
Upload - 93,8 Mbps