Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - mxracer95

#1
Bring up a slightly old thread because this one nearly perfectly matches my situation. There are lots of threads about this issue but no real good solution.

I've been using opnsense on a protectli firewall vault device behind a cable modem for almost 2 years. Any time the internet goes down, which on average is once a week but sometimes many nights in a row (maintenance?), opnsense fails to restore a WAN connection. It will show up and an IP address but no traffic will flow.

The very quick fix is to restart the Gateway Monitor (WAN DHCP) service. I used to restart the firewall, physically reconnect the ethernet cable, which all worked, but required a relatively lengthy or physical process. Restarting the Gateway Monitor (WAN DHCP) service restores connection instantly.

I really wish opnsense could handle this automatically. With all the reports of this issue I've see the last couple years, this should have been dealt with a long time ago. Until a couple months ago this was a remote, un-manned location that required sending someone out to every time there was an outage. That's unacceptable.