Messages

Greetings,

I decided to switch from PfSense to OPNsense and installed without issue up until I noticed that my WAN address did not get an IPv6 address.  Running dhcp6c on the command line in debug mode, I see that addresses are being solicited but OPNsense doesn't appear to ever do anything with them.  Can someone help?  Am I missing something obvious?  This was not an issue with my previous setup. (addresses below have been redacted...)

OPNsense 24.7.9_1-amd64
FreeBSD 14.1-RELEASE-p6
OpenSSL 3.0.15

Code Select Expand


Nov/28/2024 16:42:32: set identity association
Nov/28/2024 16:42:32: set elapsed time (len 2)
Nov/28/2024 16:42:32: set option request (len 4)
Nov/28/2024 16:42:32: set IA_PD prefix
Nov/28/2024 16:42:32: set IA_PD
Nov/28/2024 16:42:32: send solicit to ff02::1:2%igb0
Nov/28/2024 16:42:32: reset a timer on igb0, state=SOLICIT, timeo=0, retrans=1029
Nov/28/2024 16:42:32: receive advertise from fe80::eaa2:45ff:feb8:65e8%igb0 on igb0
Nov/28/2024 16:42:32: get DHCP option identity association, len 40
Nov/28/2024 16:42:32:   IA_NA: ID=0, T1=302400, T2=453600
Nov/28/2024 16:42:32: get DHCP option IA address, len 24
Nov/28/2024 16:42:32:   IA_NA address: 2607:faxx:xxxx:xxxx:xxxx:xxxx:xxxx:xxxx pltime=604800 vltime=2592000
Nov/28/2024 16:42:32: get DHCP option IA_PD, len 41
Nov/28/2024 16:42:32:   IA_PD: ID=0, T1=302400, T2=453600
Nov/28/2024 16:42:32: get DHCP option IA_PD prefix, len 25
Nov/28/2024 16:42:32:   IA_PD prefix: 2607:xxxx:xxxx:xxxx::/64 pltime=604800 vltime=42361265032448