Messages

I did not! I saw a couple similar ones but not that!

Nevermind I don't actually think I can mark it as solved

Marking as solved.

Oh wonderful! I think I'll mark this as solved!

It's still going strong with the Linux bridge config! I think I'll just leave it like this now, because I don't seem to be having any problems. I wonder if maybe the Realtek NICs were a problem before?

This is actually on a VM running on Proxmox. I was about to update this post, but I switched from using PCI passthrough for the NICs to a Bridge in Proxmox and now the issue seems resolved?!

Hello! I just recently set up HE's Tunnel Broker for IPv6 on my OPNsense install, and have it working for the most part, except devices only get IPv6 addresses after being connected for a couple of minutes, and I can see devices sending Neighbor Advertisements with TCPdump, but the router doesn't respond, and the devices only get V6 IP's after an unsolicited advertisement.

A screenshot of the RA page is attached.