"
And by the way... i only see 1 device (ever) connect(ed) , my mobilephone... No other devices... WTF?
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
Zenarmor (Sensei) / Re: Installation done, but Interfaces misconfig and zones not save?
September 05, 2024, 05:53:39 PM #2
Zenarmor (Sensei) / Re: Installation done, but Interfaces misconfig and zones not save?
August 26, 2024, 11:00:30 PM
Hi, im not sure how to understand or check this.. Default Gateway in Routetable? The wan-interface is my onboard lan ,incoming from the internetmodem. I attach a picture, i think its as you asked for?
#3
Zenarmor (Sensei) / Installation done, but Interfaces misconfig and zones not save?
August 24, 2024, 04:17:36 PM
Hi, after installing zenarmor and config, next day i got the errormessage
"Possible deployment misconfiguration: devices with public IP addresses detected
Zenarmor's health check system detected 237 devices with public ip addresses associated with them. Usually this happens because of a interface tag misconfiguration in deployment settings. "
in my thinclient opnsense, theres 1 onboard lan and 4 on a risercard.
So from my internet modem to opnsense internet is coming in on the onboard lan, outgoing to wifi hotspot and lan switch on 2 of the 4 ports on the card...
wan is chosen onboard automatically correct by zenarmor.
i switched to "lan" as security zone on the 4 card ports, applied and restartet, when refreshing page, the scurity zones selection is gone again...
im not sure what to do or if i have done until here?
a bridge is configuered in opnsense for the 4 card ports, this should not be a problem?
i cant post attachments, baceuse theyre too big !? looks like were back in 2010.... :=)
thanks for any help!
casi
"Possible deployment misconfiguration: devices with public IP addresses detected
Zenarmor's health check system detected 237 devices with public ip addresses associated with them. Usually this happens because of a interface tag misconfiguration in deployment settings. "
in my thinclient opnsense, theres 1 onboard lan and 4 on a risercard.
So from my internet modem to opnsense internet is coming in on the onboard lan, outgoing to wifi hotspot and lan switch on 2 of the 4 ports on the card...
wan is chosen onboard automatically correct by zenarmor.
i switched to "lan" as security zone on the 4 card ports, applied and restartet, when refreshing page, the scurity zones selection is gone again...
im not sure what to do or if i have done until here?
a bridge is configuered in opnsense for the 4 card ports, this should not be a problem?
i cant post attachments, baceuse theyre too big !? looks like were back in 2010.... :=)
thanks for any help!
casi
Pages1
