"
I'm also having a lot of latency since upgrading using guard home plugin. Was fine prior to upgrading from 25.7.x but ever since 26.1.x it's been really latent by a few seconds to load both local and non-local sites.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
26.1 Series / Re: after upgrade to 26.1 and 26.1.1 Problems with Unbound and Adguard
February 08, 2026, 04:28:24 AM #2
25.7, 25.10 Series / isc-dhcp: static mapping CSV export
August 04, 2025, 09:52:25 PM
o isc-dhcp: add static mapping CSV export
Anyone know the steps to actually accomplish this? Can this be done in the GUI and if so where? I'm on 25.7.1.
Thank you.
Anyone know the steps to actually accomplish this? Can this be done in the GUI and if so where? I'm on 25.7.1.
Thank you.
#3
24.1, 24.4 Legacy Series / Firewall Rule
July 19, 2024, 10:55:59 PM
I have a firewall rule that's not working right and not sure why.
Protocol = IPv4+6 *
Source = CAM_INET_ALLOWED (Alias)
Port = *
Destination = |PrivateNetworks (Alias)
Port = *
Gateway = *
Schedule = *
CAM_INET_ALLOWED Alias is set to Type Host and has 3 internal IPs under contents. It is Enabled.
The |PrivateNetworks alias is also enabled and used in several other VLANs, however the Source for every other VLAN is "(vlan name) net".
When I change the non-working rule to "IPCAM net" the IPs start talking to the internet, but so do all my cameras, and I am trying to isolate the cameras from talking to the internet and only allow a few devices on the vlan to actually talk to the internet.
Protocol = IPv4+6 *
Source = CAM_INET_ALLOWED (Alias)
Port = *
Destination = |PrivateNetworks (Alias)
Port = *
Gateway = *
Schedule = *
CAM_INET_ALLOWED Alias is set to Type Host and has 3 internal IPs under contents. It is Enabled.
The |PrivateNetworks alias is also enabled and used in several other VLANs, however the Source for every other VLAN is "(vlan name) net".
When I change the non-working rule to "IPCAM net" the IPs start talking to the internet, but so do all my cameras, and I am trying to isolate the cameras from talking to the internet and only allow a few devices on the vlan to actually talk to the internet.
Pages1
