Messages

Have set up a few HA multi-wan opnsense boxes and have always been able to ping both WAN interfaces for monitoring using a floating ICMP rule.  On a new setup I can only ping the WAN interface with the active gateway i.e. by adjusting the tiering or weight to make the backup GW active I am then able to ping the interface but can no longer ping the primary.

Have checked the config with other sites able to ping both whether active or not and cannot see any difference, what would be preventing the ping response?

Thanks

Managed to get mine online, changing to 1000BaseT did not work, went through adjusting settings including Overwrite Global Settings but was not working, tried 1000BaseSX and it came up.  Removed the other settings I had adjusted and it stayed up.  Tried setting 1000BaseSX on second box but no joy, gave a reboot still not working changed to 1000BaseLX and it came up.

On the dashboard they are both showing as 1000Base-SGMII <full-duplex,rxpause,txpause>

For a backup ether WAN connection.

Any resolution on this one?

Dual DEC2750 with compatible FS SFP-GB-GE-T, both unable to communicate, was working when initially set up