Messages

Until now I could not find any cpu information. Will try to open the device tomorrow. But I think there is a general problem with this devices. Two usg40 and one usgflex100 are unable to give serial access. Tested same client serial access with an hp switch and a tplink switch without any problems


Gesendet von iPhone mit Tapatalk

Did not find anything about this. But also when the system is booted and accessible through web interface I can not get any output over serial with minicom, putty, screen and so on. Seems to be a big problem what I found on the net. Maybe wrong hardware for this project


Gesendet von iPhone mit Tapatalk

ZyXEL manual says to use bautrate about 115200 and only hit enter to login.

I know it is a ZyXEL topic but hopefully someone already installed OPNsense on this hardware [emoji6]


Gesendet von iPhone mit Tapatalk

Baudrate is set to 115200


Gesendet von iPhone mit Tapatalk

Hi everyone, I got an older ZyXEL USG40 from a customer and I am trying to install OPNsense on this hardware with the serial installer.

I have an USB RS232 Dongle and a Null Modem Cable. When I try to make a serial connection with putty or screen I only get a blank screen.

Any Ideas how to fix this?


Gesendet von iPhone mit Tapatalk