1
24.1 Legacy Series / Re: gui keeps quitting but unit is running fine
« on: February 05, 2024, 09:30:08 pm »
do not have any vlans
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
24.1 Legacy Series / Re: gui keeps quitting but unit is running fine
« on: February 02, 2024, 02:14:53 pm »
IPS running, disabled it and it made no difference. I do not have Crowdsec installed.
3
24.1 Legacy Series / gui keeps quitting but unit is running fine
« on: February 02, 2024, 01:26:06 am »
have had this protectli running since sept and it reboots every morning at 2am I tried to log in this morning and timed out. I connected the computer directly to the unit and no problems. Gui is working fine, so lets reboot everything and try again
ITS comcast surfboard 6183 modem, oprotectli firewall, asus 3100 router...wired back to my home network and after reboot its fine gui works. About an hour later I was in the interface and it just quit working. I again connected my computer directly and its up and running and the gui is fine.
Again connect to the GUI works for a while and then just blank out in the GUI and can not reconnect
Went back a month, and did a restore. Updated everything and ok gui at first. 1 hour later and gui is gone and can not log back in.
I have always used chrome browser so I tried firefox same thing.
what would make it shut down the gui and not allow a connection except when a computer is hardwired to the unit.
I am thinking router but it has be up 24/7 for years and no problems.
I found a 1/2023 bios and flashed the router with it. I know at that time it was in use when I got the protectli and there were no problems at that time.
ITS comcast surfboard 6183 modem, oprotectli firewall, asus 3100 router...wired back to my home network and after reboot its fine gui works. About an hour later I was in the interface and it just quit working. I again connected my computer directly and its up and running and the gui is fine.
Again connect to the GUI works for a while and then just blank out in the GUI and can not reconnect
Went back a month, and did a restore. Updated everything and ok gui at first. 1 hour later and gui is gone and can not log back in.
I have always used chrome browser so I tried firefox same thing.
what would make it shut down the gui and not allow a connection except when a computer is hardwired to the unit.
I am thinking router but it has be up 24/7 for years and no problems.
I found a 1/2023 bios and flashed the router with it. I know at that time it was in use when I got the protectli and there were no problems at that time.
Pages: [1]