"
No one has seen this?
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
23.7 Legacy Series / Re: Fresh install, INTs are correct, unable to ping or access LAN
January 16, 2024, 12:06:18 AM #2
23.7 Legacy Series / Fresh install, INTs are correct, unable to ping or access LAN
January 15, 2024, 09:53:05 PM
Hello,
I am new to OPNsense and this forum. I searched but have been unable to find the answer to this./
I performed a new install of 23.7 with no changes to the default configuration. After I assigned the IP address to the LAN interface. I cannot ping; from the unit to the PC plugged into the it (the PC's firewall is off) OR from the PC to the LAN. Of course I cannot access the GUI either.
Because I am so new to this software, I don't know if there is something else that I need to do to enable the LAN/Web GUI, or do I have a defective new Protecil device?
Thank you
I am new to OPNsense and this forum. I searched but have been unable to find the answer to this./
I performed a new install of 23.7 with no changes to the default configuration. After I assigned the IP address to the LAN interface. I cannot ping; from the unit to the PC plugged into the it (the PC's firewall is off) OR from the PC to the LAN. Of course I cannot access the GUI either.
Because I am so new to this software, I don't know if there is something else that I need to do to enable the LAN/Web GUI, or do I have a defective new Protecil device?
Thank you
Pages1
