Messages

1

Zenarmor (Sensei) / Re: Opnsense with Zenarmor Free, block but not

« on: December 15, 2023, 01:59:14 pm »

Hi,

I believe the ISP detection is correct.
Additionally, it blocks internet connection if there are too many issues, so I need to find a firewall that blocks effectively.

If I protect the LAN interface, will it also protect against external (internet) attacks ?
But problem if I protect only LAN: "For Bridge Mode, you need to assign an interface for each of the lan and wan security zones."


So if I understand correctly I should let Zenarmor handle the Bridge and not configure the Bridge in Opnsense?

2

Zenarmor (Sensei) / Re: Opnsense with Zenarmor Free, block but not

« on: December 14, 2023, 01:58:16 pm »

Good question.

I created the bridge mode in Opnsense (as indicated in the doc) then I installed Zenarmor.

I have:
LAN: bce1
WAN: bce0
MGMT: em0
Bridge: bridge0

On Zenarmor, I checked bce0 (lan) and bce1 (wan). I don't see any other interface under Zenarmor.

Sorry, I'm new to this product 

3

Zenarmor (Sensei) / Re: Opnsense with Zenarmor Free, block but not

« on: December 14, 2023, 12:15:02 pm »

And I would like to specify that I have configured it in Bridge mode (L2).
LAN, WAN, Bridge, and MGMT interfaces.

4

Zenarmor (Sensei) / Opnsense with Zenarmor Free, block but not

« on: December 14, 2023, 11:01:48 am »

Hello,
I am currently testing Zenarmor Free on OPNsense.
The product looks interesting, but I am encountering a strange issue.
The connection logs indicate that a connection has been blocked (there is a red shield icon), but my internet service provider, who uses Abuse, reports receiving an alert.
I might have misconfigured something in OPNsense or Zenarmor, but I'm not sure what it could be.

Does anyone have any ideas?

Please see the attached screenshot.

Thx

Philippe