Show posts

Hi, Sorry about the question I see this one alot, searched the forum, tried to troubleshoot but been staring at this issue so long I might be missing something obvious.

I am configurig my first vlan for what will be a slightly complicated setup.
Trying to setup an initial managment vlan on the LAN interface. So going simple first to check all is good before applying a more complex setup. Unfortunatly I have already hit a bit of a roadblock.

I am getting a DHCP address on the endpoint from the dhcp server on the vlan interface in question (LAN_MGMT). I can also see this endpoint address in the leases for the dhcp server on LAN_MGMT.
Endpoint is on an access port with VLAN 10 assigned, so I am sure the network is configured correctly.

I can also see the in the firewall logging live view the rule applied on the LAN_MGMT interface when I try to go to the LAN_MGMT IP. Both 80 and 443 depending if I use the LAN_MGMT ip with or without https://

Here is the steps I did:

Created vlan as device vlan0.1.10 and Tag 10 on the LAN interface (igc1)
Added to Interfaces through assignments named LAN_MGMT, set a static IPv4 within the subnet I will use and enabled it.
Added a copy of the default allow all rule to the LAN_MGMT Interface changing source interface to LAN_MGMT.
Configured DHCP on the LAN_MGMT interface and enabled.
Ensured the 'Listen Interface' is set to All (reccomened) (Also tried just LAN, LAN_MGMT), in the settings.

I have reset states in Firewall
Rebooted Firewall
Assigned a static IP on the endpoint in the LAN_MGMT subnet trying both no gateway and gateway of the LAN_MGMT

I still can not ping the LAN_MGMT interface, or get to the webgui

My setup is on version 23.7.

Kinda at a loss and worndering if I have missed something obvious.

Messages - FizzerUK

23.7 Legacy Series / Re: Can not Ping or get to webgui on VLAN, getting a DHCP address

23.7 Legacy Series / Can not Ping or get to webgui on VLAN, getting a DHCP address