Messages

Those ports mentioned "50000-500015" you sure about that? Cause we have only 65535
Shouldn't be it 50000-50015?

When you had OPNsense installed, did you use and self configured rules or NAT configuration?
Did only SIP not work or were you at all not able to reach internet?
Did you try on OPN check the live sessions tab and see what is OPN doing when a packet is hitting the INGRESS and EGRESS interface?

Regards,
S.

okay, I didn't have Zenarmor installed so I had to go through the process to do so.  All that I see in there from the IP of the repeater is a DHCP request to the firewall.  Nothing else is showing at all, which doesn't make much sense.

Those ports mentioned "50000-500015" you sure about that? Cause we have only 65535
Shouldn't be it 50000-50015?

When you had OPNsense installed, did you use and self configured rules or NAT configuration?
Did only SIP not work or were you at all not able to reach internet?
Did you try on OPN check the live sessions tab and see what is OPN doing when a packet is hitting the INGRESS and EGRESS interface?

Regards,
S.

definite fat finger on the port range.  I fixed that.

Everything worked except the repeater.  I was able to use my SIP phone and the internet with no problem.  It is using the NAT rules there were setup by default when the installation was done.

I will take a look at that live sessions tab and update. 

setup:  Protectli 4 port unit with 23.7 installed on it fresh.  Only setup done is LAN side address and DHCP scope.  all to all rule from LAN to WAN.  Internet and everything else, SIP phones, etc work fine.

I'm an RF engineer, and I'm working on a Motorola DMR IP Site Connect setup.  It uses a master repeater in a colocation facility with a remote firewall with UDP ports 50000-50015 port forwarded to it from the internet.  There are 4 other remote sites currently connected to it, and working great.

I'm trying to setup a 5th site at my home using the Protectli.  My home Motorola repeater refuses to connect to the master site despite my best efforts when using OPNsense.  I put the home unit directly onto the internet, and it connects and works fine.  I have one of those GL Inet Opal travel routers that I use when I'm on the road, so I installed that instead, and it actually worked using this!

This got my brain going a little bit, so I tried Untangle on the Protectli, which I really don't like, but it worked, too.  So, I wiped the unit and tried pfsense.  This did NOT work.

I'm looking for some thoughts on next troubleshooting steps.  This one has me stymied.  Thanks for any thoughts or direction, I'm at a loss.