"
Ah nice one. I actually had a guide for that, but that one stopped before the tunables changes.
Better go for offical docmentation next time. Thx man.
Better go for offical docmentation next time. Thx man.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
Tutorials and FAQs / Re: Can not reach other LAN participants through opnsense
October 18, 2023, 02:52:19 PM #2
Tutorials and FAQs / Can not reach other LAN participants through opnsense
October 18, 2023, 02:30:48 PM
Hi all,
following issue. I am running OPNsense on a small barebone. It has 5 ethernet ports.
I am using 1 as WAN and the other 4 are grouped and used as LAN.
My entire LAN connects to the designates LAN ports over various ways.
The DHCP server in the opnsense shows all off the participants i expect as leases.
One of them is an openwrt access point. the access point is also configured to be a DHCP client.
All WiFi and LAN users are getting the ip adresses shown in the leases. All of the participants can access the internet via WAN.
But i can't connect to the openwrt access point. I also can not ping it. i tested it with 2 of my PCs no one gets access to it.
If i go via Wifi with the laptop i can access the accesspoint webgui.
If i do a IP adress sweep with Angry IP scanner it shows the PC itself and the opnsense gateway with minimal latency. All the other participants are sown as "alive" but with massive latencies.
But neither of this participants show any problems when i work with tem.
If i ping the second pc in my room which both connect to a small switch and then to the opnsense, i also can ping it.
So it seems that all network request going through the opnsense are somehow blocked. As long as i remain in a certain switch subnetwork it seems to work.
What i am missing here? It seems that the group is somehow not linked between itself?
following issue. I am running OPNsense on a small barebone. It has 5 ethernet ports.
I am using 1 as WAN and the other 4 are grouped and used as LAN.
My entire LAN connects to the designates LAN ports over various ways.
The DHCP server in the opnsense shows all off the participants i expect as leases.
One of them is an openwrt access point. the access point is also configured to be a DHCP client.
All WiFi and LAN users are getting the ip adresses shown in the leases. All of the participants can access the internet via WAN.
But i can't connect to the openwrt access point. I also can not ping it. i tested it with 2 of my PCs no one gets access to it.
If i go via Wifi with the laptop i can access the accesspoint webgui.
If i do a IP adress sweep with Angry IP scanner it shows the PC itself and the opnsense gateway with minimal latency. All the other participants are sown as "alive" but with massive latencies.
But neither of this participants show any problems when i work with tem.
If i ping the second pc in my room which both connect to a small switch and then to the opnsense, i also can ping it.
So it seems that all network request going through the opnsense are somehow blocked. As long as i remain in a certain switch subnetwork it seems to work.
What i am missing here? It seems that the group is somehow not linked between itself?
Pages1
