Messages

i tried both sonarr and portainer (one with and without ssl) and neither are working.
its worth mentioning I only forwarded the internal 80/443 on my LAN rather than exposing on the WAN - I assume this is fine if I don't want any of my servers to be public facing.

any other idea's on what to test? my opnsense is more or less out of the box, I'm not doing anything particularly interesting with my configuration outside of this.

Thanks, I've attached the caddyfile and log and the letsencrypt challenge works successfully so it has been able to request a certificate, its when i navigate to the page I get that error in my browser

Great plugin however when i set it up and try to navigate to the domain i've configured (as per tutorial )

subdomain.domain.com uses an unsupported protocol.
ERR_SSL_VERSION_OR_CIPHER_MISMATCH

I'm using the dns challenge to generate the certificate, any ideas why this would cause a problem?

Thanks guys, you were right!
Even though I tried a couple of cables, I found switching a 3rd time did the trick.

Using ethtool on the proxmox host did highlight the issue that it was negotiating at 100Mbps so lesson learned there.

Appreciate the help  :)

Thanks - the issue is on my LAN interface not my WAN, I just was saying that I verified that the limitation is not my WAN link (if that makes sense) I tested WAN speed using speedtest-cli in the console on my router to verify that was not the bottleneck.

Yes I can confirm i mean 100Mbps and the cable supports 1gbit.
Also can confirm there are no shaping rules/pipes in place.

Hi All,

This issue has got me scratching my head!

For some reason the LAN interface from my opnsense router is limiting itself to 100mbps however it is a 2.5gbps port.

I have tested my wan link which is fine and pulling at 1gbit (internet speed), when i test transfers between devices on the switch they are performing at 1gbit speeds however as soon as I run a speedtest on a device connected to the switch, speeds max out at 100mbit

When I look at the LAN interface in settings it shows the connection for some reason as 10gbit (as below), I'm not exactly sure where I can see the negotiated connection speed in the OPNsense webui however when I look at the switch the light would indicate the connection has been negotiated at 1gbit.

I have replaced the patch cable just in case, so from here I need to assume its a software issue.

For context, I'm running opnsense virtualised on a proxmox host on a N100 device with 4x 2.5gbit ports

Media   10Gbase-T <full-duplex>

Any ideas on what I can test/check next?