Messages

Hi, hopefully this is right section of the forum to be posting to.

I started setting up OPNsense the other day and was able to get my LAN devices to see the internet, but nearly none of them are pulling full speed over ethernet or WiFi from my access point. I ran a speed test on a few devices, here are the results:

OPNsense:
   Wired:
      Download: 907.13 Mbps
      Upload: 40.84 Mbps

Fold 4:
   Wireless (Cellular Off):
      Download: 114 Mbps
      Upload: 37.8 Mbps
   Wired (Lenovo RTL8153-04 J6-4)
      Download: 399 Mbps
      Upload: 41 Mbps

Surface Book 2:
   Wireless:
      Download: 196.06 Mbps
      Upload: 41.68 Mbps
   Wired (Lenovo RTL8153-04 J6-4):
      Download: 135.97 Mbps
      Upload: 40.89 Mbps

Xbox Series S:
   Wireless:
      Download: 259.49 Mbps
      Upload: 41.08 Mbps
   Wired:
      Download: 366.37 Mbps
      Upload: 41.21 Mbps
      
Shield TV Pro 2019:
   Wired:
      Download: 75.81 Mbps
      Upload: 43.15 Mbps

Desktop PC:
   Wired:
      Download: 892.80 Mbps
      Upload: 41.80 Mbps

Earlier today, I had my Surface Book only getting 75 Mbps down on a few different test attempts.

As for my hardware, I'm running OPNsense in a VM through Proxmox, which has the internal ethernet port of the PC passed through as a PCI device. WAN comes in on VLAN100 through my Cisco switch, while LAN is set to VLAN200. I've also added the parent device as its own interface, enabled but with no IP set, but that doesn't seem to have made a difference despite what I've been reading.

Any suggestions on troubleshooting I can do to figure out what's going on?