Messages

# opnsense-revert -r 26.7.1 realtek-re-kmod

this worked for me

This is only true for the main mirror at the moment: if you want to force a reinstall use this:

# opnsense-update -fbkr 26.7.2

The realtek plugin should work again afterwards.  But still curious there was a second panic unrelated to realtek...


Cheers,
Franco

hi,

i did that and enabled the realtek plugin. box is booting but no ip adresses are given to the 2 realtek nics. even after adding new ip adresses via shell, they still remain empty and box is unreachable. any hints?

regards
ralf

Hi,
Use the console, option 12, type 26.7 when prompted.
dont close terminal when the patch notes are showing. press q instead. 

Hi,

- I am running a cable from LAN1 on the Fritz!Box to the NIC I have selected as my WAN interface in OPNsense when I installed it

no. put the fritzbox lan1 on your switch. it can be in the same subnet as the opnsense. that way u can still use wlan or telephony from your FB

- I put Fritz!Box in bridging mode, essentially demoting it to an IP device

after you set your FB in bridging mode, make sure you use the Port you choosed for bridging to connect to the wan nic of your opnsense device. set the wan interface to dhcp, dhcpv6. you will get an own public ip on your wan interface then. see attached screenshot. in that case lan 4 goes to your wan nic on your opnsense.

set the opnsense lan port to the same network as your fb, pihole and so on and connect it to your switch.

Voila, your done