Show Posts
1
23.1 Legacy Series / Apply button circle spiining, never stops
« on: June 21, 2023, 02:04:23 am »
Hi all,
New install of opnsense (I had pfsense before) and I like it so far. It has been updated. I have a strange issue. I am using the DNS blacklist feature in Unbound. I selected several lists of the ones offered and then I hit the Apply button. I see the spinning circle, but it never stops. After about an hour, it was still spinning. I navigated away from the page and when I went back I could see the selections that I made. I thought all was good. Later that night, the firewall stopped passing traffic and I had to reboot it though the console. I found a list that I had chosen was blocking some sites, so I removed it and hit apply. The same exact thing happened even though I let it run all night. I had to reboot it again through the console. I have not touched it again as I am afraid. Has anyone else seen this behavior? I checked the logs and did not find anything out of the ordinary. Thanks in advance.
New install of opnsense (I had pfsense before) and I like it so far. It has been updated. I have a strange issue. I am using the DNS blacklist feature in Unbound. I selected several lists of the ones offered and then I hit the Apply button. I see the spinning circle, but it never stops. After about an hour, it was still spinning. I navigated away from the page and when I went back I could see the selections that I made. I thought all was good. Later that night, the firewall stopped passing traffic and I had to reboot it though the console. I found a list that I had chosen was blocking some sites, so I removed it and hit apply. The same exact thing happened even though I let it run all night. I had to reboot it again through the console. I have not touched it again as I am afraid. Has anyone else seen this behavior? I checked the logs and did not find anything out of the ordinary. Thanks in advance.