Messages

Thanks I will try to figure it out.

perfect. thanks

Pressing tab twice doesnt do anything on my shell. I just wondered if there was a command which lists all commands eg. sysctl, free, cp, mv, ls, etc. thanks

I meant the commands which are pre installed with opnsense, not all commands. thanks

Hello,

Where can I see a list of commands which can be executed from the opnsense shell?

Thanks

Hello,

at the wireless devices page
https://192.168.1.1/interfaces_wireless_edit.php

it says I have no wireless devices but I have 2.

I am running opnsense in virtualbox.

How can I fix this?

Thanks

Hello,

at the wireless devices page
https://192.168.1.1/interfaces_wireless_edit.php

it says I have no wireless devices but I have 2.

I am running opnsense in virtualbox.

How can I fix this?

Thanks

reinstall fixed it

Hello,
When opening the following
https://192.168.1.1/interfaces.php?if=lan

I get this message
Fatal error: Failed opening required '/usr/local/www/interfaces.php' (include_path='/usr/local/etc/inc:/usr/local/www:/usr/local/opnsense/mvc:/usr/local/opnsense/contrib:/usr/local/share/pear:/usr/local/share') in Unknown on line 0

I am running opnsense in virtualbox
How can I fix this?

Thanks

Just bought a USB -C to USB adapter so I plugged in the USB Network adapter with a network cable to my tplink router and now get the following continuously.
ue0: link state changed to UP
ue0: link state changed to DOWN
ue0: link state changed to UP
ue0: link state changed to DOWN


I also tried through a different router with DDWRT firmware configured as a switch with both laptops plugged into the switch but it looks impossible to open the opnsense GUI even though it says I can open the GUI at 192.168.1.1, the other router is set to 192.168.1.2
Do you have any ideas how to at least access the GUI?
Thanks

Thanks for all the info but as a complete newbie it is way above my head and will take a while to understand.

Getting down to the very basics, is it possible to plug my opnsense laptop into my tplink router and then access the opnsense GUI from my other laptop which is also plugged into the same tplink router? If yes then how can I do this? 

If I could just start off by accessing the GUI I might be able to make some headway.

Thanks

I just grabbed my usb to rj45 but its usb c and the old laptop doesnt have a usb c socket so until I get a usb c to usb adapter could this be configured to work on a single rj45 along with the built in wifi and another usb wifi if needed? thanks

ps. If needed to get this up and running I have a usb to rj45 so the full setup could have 2 x rj45s and 2 or 3 wifis.

yes it has a single rj45 on the side and it is plugged in to my tplink router which has internet, my other laptop is also plugged into the same tplink router, the opnsense laptop has built in wifi and I have a couple of usb wifi dongles which I could use if needed. do I have enough hardware to get this setup as a router? basically I thought it was enough just to connect the opnsense laptop to the tplink router and then access it with my other laptop to configure it via the gui at an ip address I specify, I just wanted to configure a new wifi on dhcp from the gui. thanks

ps. even if I try option 2: set interface ip address, after completing the process it says I can access the gui on that ip for example 192.168.1.150 but when I open that ip on my other laptop it does not load.