Messages

I was trying to follow this tutorial, but the problem is that I don't see the virtual IP I defined as a drop down option under "Translation / target"  when I try to define Firewall: NAT: Outbound
Any idea what I did wrong ?

After upgrade to 23.1.2 I can see the Virtual IP I defined earlier. However still can't access my modem.

I already tried this
I can't access the modem if I enter the IP manually

I think I have a similar issue
I was trying to get access to the GUI of my modem following this tutorial post https://forum.opnsense.org/index.php?topic=8616.0

The problem is that when I try to create outbound NAT I don't see the virtual IP I defined as a drop down option under "Translation / target"

I think its related to this https://forum.opnsense.org/index.php?topic=32587.0

Yes I don't really need /30
I originally made it /32 , but then when I saw its not showing up I tried to change it to /30 just to make it the same as in the original post to see maybe it will help

Here are the Virtual IP settings and the Translation / target dropdown

I'm not a huge Opnsense expert, but I still know how to follow instructions.

Of course I created it and I made sure it's there

I was trying to follow this tutorial, but the problem is that I don't see the virtual IP I defined as a drop down option under "Translation / target"  when I try to define Firewall: NAT: Outbound
Any idea what I did wrong ?