Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Flappie

#1
Hello everyone,

I have configured several VLANs in OPNsense and assigned them to interfaces.

I only want to use the built-in Unbound DNS server on my IoT VLAN. For my LAN, I use my own DNS servers.

However, when you configure Unbound on only the IoT interface, Router Advertisements also advertise the IP address of the interface as a DNS server on the other VLANs, even though Unbound is not running on those interfaces.

As a result, my LAN is now also receiving an IPv6 DNS server via Router Advertisements, using the IP address of the LAN interface on OPNsense. But Unbound is not running on that interface at all.

Is this a bug, or is this the expected behavior?
#2
Quote from: mimugmail on January 27, 2023, 04:40:27 PM
Just edit one firewall rule and save again, then it will be there.

How to edit when the rules/group are not visible?
#3
FYI, removing os-wireguard and reinstalling os-wireguard-go brings back the group with the rules.
#4
Hi,

Installed Opnsense 23.1 and imported my config from version 22.7.1
I installed "wireguard" (not wireguard-go as in the previous 22.7).

Howver, i'm missing the "Wireguard group" under firewall rules.
This group was still there with version 22.7.

So, all my WireGuard clients are connected however they can't access anything since al firewall rules are missing.