Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - Sasquatch5177

#1
traceroute command works but mtr doesnt on icmp2 for me. It's the same as before.
#2
Just a quick heads-up, it's a bit weird but doing speedtest over speedtest I can see that I can sometimes get the full bandwidth, its like 50% of the time 1.2gbps and the rest 1.5/1.6. When I can get 1.6 it is very slow to go to 1.6 tough.
Here's a screenshot of a speedtest history.

#3
Unfortunately Bell doesn't offer IPv6...
#4
It's a 1500/940 package and I have no problem maxing the upload at around 950/960 mbps
#5
Hi guys so let me explain what is going on, its not a huge problem for me but i'd like to get it fixed.

I'm with Bell FTTH in Canada I connect with PPPoE and they give me 1.5gbps, I bypassed their router with mine, with a 57810S NIC card 2x SFP+ interfaces.

When I try a WAN speedtest with the command "iperf3 -c bhs.proof.ovh.ca -u -b 2g -R" on opnsense it gives me 1.64gbps which is exactly what i'm supposed to have. The problem is when I try the same command on my server on my LAN or my computer I cannot get above 1.34gbps.

The server and computer are connected at 2.5gbps on a 10gbps capable switch. When I do iperf between my PC and my server I get 2.35gbps so I saturate 2.35gbps. Also, when I try the same iperf with opnsense being the host for iperf I get the same speed 2.35gbps.

Honestly i'm not a pro so I didn't try a lot of things, I played with MTU but it didn't change anything, any ideas?

Thanks.