1
Zenarmor (Sensei) / Re: Major issues after latest update
« on: November 11, 2022, 08:53:19 pm »
Reinstalling produces this error.
Show Posts
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages: [1]
2
Zenarmor (Sensei) / Major issues after latest update
« on: November 11, 2022, 08:51:01 pm »
Checking on my system this month I noticed Elastic search suddenly stopped working, I tried reinstalling, and purging and wasn't getting anywhere with reports being run after updating to 1.12... I tried uninstalling, noticed I wasn't running 22.7.7_1, and updated that... and finally it came up twice tried.
My latest issue is upon L3 not only is a fraction of the traffic going through the netmap driver but it's monitoring my Private Internet Access ovpnc1 client post encryption. It doesn't see any connections outside of DNS that goes towards my Pi-Hole on network. I get zero blocks, shown of threats when with the previous engine I was getting reports and threats stopped regularly, I could see IP's, and addresses Pre-Encrypted traffic.
I'm also getting ping failures across the board that was momentarily solved via adding Tunables dev.netmap.buf_num 1000000. Just being able to upload without time-outs requires me to reset zenarmor to factory defaults and not move forward with the rest of the setup.
I'm completely stumped here. This has been working flawlessly for quite some time. Just in order to browse without failures right now I have to keep the packet engine stopped.
Was anyone seeing this?
My latest issue is upon L3 not only is a fraction of the traffic going through the netmap driver but it's monitoring my Private Internet Access ovpnc1 client post encryption. It doesn't see any connections outside of DNS that goes towards my Pi-Hole on network. I get zero blocks, shown of threats when with the previous engine I was getting reports and threats stopped regularly, I could see IP's, and addresses Pre-Encrypted traffic.
I'm also getting ping failures across the board that was momentarily solved via adding Tunables dev.netmap.buf_num 1000000. Just being able to upload without time-outs requires me to reset zenarmor to factory defaults and not move forward with the rest of the setup.
I'm completely stumped here. This has been working flawlessly for quite some time. Just in order to browse without failures right now I have to keep the packet engine stopped.
Was anyone seeing this?
Pages: [1]