Messages

I'd start from a simple setup.
Lenovo M720q with 1 i226v PCIe NIC - check if this config works correctly.

Interfaces: Overview - this section should be very clean with minimal setup, validate that you getting correct default gateway from the ISP.

[2025-10-22 15:51:57 UTC (releng/14.3, 14.3-RELEASE-p5)]

Hi,

The 'p#' - related to security patches on top of existing release.
You can see it stated for each security patch on official www: https://www.freebsd.org/security/advisories/

Example from the latest - you can see that "latest p#" = p5

Corrected:      2025-10-22 15:48:25 UTC (stable/15, 15.0-STABLE)
                2025-10-22 15:50:30 UTC (releng/15.0, 15.0-BETA2-p1)
                2025-10-22 15:48:51 UTC (stable/14, 14.3-STABLE)
                2025-10-22 15:51:57 UTC (releng/14.3, 14.3-RELEASE-p5)

Latest 24.1.8 (non-business) - Reload option for quick connect/disconnect on Interfaces: Overview
No idea if you have same UI tho

Console connection ?

console - option 11 - restart all services.
Try restart and access https again.

There was similar issue here (resolved already I think):
https://forum.opnsense.org/index.php?topic=38536.0

Since new interface menu details no longer holds info about connection time, as workaround I use attached command:

grep -wns "IPCP: LayerUp" latest.log | cut -b 10-29

So instead of getting connection time, I can see when the interface was connected.
Not perfect, but works.

Could it be related to IPv6 ?
Looks like similar issue reported:

https://forum.opnsense.org/index.php?topic=38593.msg188923#msg188923

Not clean install - update from 24.1

Works fine.

After update to released 24.1.1 issue no more exist.
Idk what happened, but also boot log now clean and displays correct WebGUI start:

webgui_configure_do[249] done.   
webgui_configure_do[249] Starting web GUI...

Nope
Just vanilla fresh installation of 24.1
Seems that nothing unusual configured on my side.
OPNsense box connected to "dumb" switch, so I guess it is not a "network related issue".   

After full system reboot no access to WebGUI, however ping OK.
So I do SSH and go to option 11 (all services restart).
Only after that I have access to WebGUI.

On boot log I have 2 lines with indication of WebGUI starting failure.

Is there any way to get information about current interface uptime?

On 23.X it was available like on screenshot from this post:

https://forum.opnsense.org/index.php?topic=25503.msg122552#msg122552

Have same issue.

After upgrade to 24.1 (clean install) Web Gui no longer properly initializes.
This is what I see on the boot log:

webgui_configure_do[259] failed.   
webgui_configure_do[259] Starting web GUI...

After restart all the services via SSH WebGUI available again.

Yes - same behavior here.

I cannot get stable results for the UPNP functionality.
Right now after several restarts I do have UPNP working OK.

Guess I will leave it as is.
Until next time   :D

Warframe
Latest OPNsense - not a fresh install.

UPNP - enabled.
Ports detected and status reported on UPNP Status page.
Warframe - reports Strict NAT when "Analyze network" performed.

I'm able to join multiplayer games (multiplayer sessions within Waframe), so it is not clear to me what exact issue is...