Messages

I have traffic going out of OpenVPN just fine. I have the ability to control who goes through the VPN and not with the LAN firewall rules. I'm trying to duplicate my LAN rules with the OpenVPN rules on OPT1. However, webpages stop working the moment the rules are enabled, even if I don't use the block rules at the bottom.

Is there something I'm not getting in terms of how to control the traffic in OPT1 like I do with LAN?

https://pastebin.com/kTickCyz

I don't follow it to the T but the main parts are there. I followed this before the upgrade and it worked just fine.

The real issue that gets me is before I could make my OpenVPN connect and not lose internet connection. Now when it connects everything just stops working.

Previously I was able to setup a OpenVPN client and connect it without losing all internet access. The moment the service is enabled all access goes down. I previously had all my traffic going out of the OpenVPN tunnel but following my guide now after upgrading does not seem to work no matter what I try.

Is this a known issue with    OPNsense 22.7.3_2-amd64

I have an OpenVPN server setup on a remote server and have my opnsense connected but not sure how to route all my traffic through the VPN. I know it has something to do with NAT and the firewall but I'm not sure how. Guides on the web seem out dated and did not work after following them. I'm on the latest version of OpnSense.

My setup: