Messages

I know, but I don't have access to the person's internet credentials.

192.168.0.3 is for wan opnsense, 192.168.1.1 is for wan.
I used this link but apparently I was doing something wrong, after work I will sit down to try the configuration again.

This is my thread, I created my account anew.
Compal ch7465lg-lc, ISP: UPC.
The router has the following functions disabled by the operator: nat, port and modem mode forwarding, passthrough. These options are not there, I know that in other configurations of this router they should be. The contract is not on me and I can't ask the operator to activate these functions.

Ok, change of concept:



We have a router from the ISP (192.168.0.1)
I want to connect a computer with OPNSESNE to it (configured to 192.168.0.2).
I connect usb-ethernet to it (configured to 192.168.0.3).
The usb-ethernet card is connected to a switch (which I bought THIS WEEK [Qnap QSW-2104-2t]).
What should I do (how should I configure opnsense) to use the built-in rj45 connector on my computer (labeled LAN in opnsense) to access the Internet on the switch with the usb-ethernet card (labeled WAN)?
Regards.