"
This just makes no sense.
Unchecking the disable gateway monitor just plain fixed it.
Unchecking the disable gateway monitor just plain fixed it.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
22.1 Legacy Series / Re: WAN Speedtest drops 90% after exactly 5 minutes of saving interfaces.
May 11, 2022, 06:06:12 PM #2
22.1 Legacy Series / WAN Speedtest drops 90% after exactly 5 minutes of saving interfaces.
May 11, 2022, 07:17:29 AM
I have a Deciso DEC850 running OPNsense 22.1.6-amd64.
When the OPNsense is connected to a fiber modem/router I get full speeds continuously.
When connected to a fiber mediaconverter with a VLAN 100 tag on the WAN it drops after exactly 5 minutes to about 100-115 Mbps.
Very easy to reproduce, it takes 5 minutes everytime.
Can anyone tell me if there is anything specific happening 5 minutes after saving an interface?
Saving and applying an interface will somehow reset it and it has full speed again 946/947 for the whole of 5 minutes.
Traffic through my VPN does not get limited.
I have no Shaper active.
I have assigned and enabled the physical interface that the VLAN is tagged on.
When the OPNsense is connected to a fiber modem/router I get full speeds continuously.
When connected to a fiber mediaconverter with a VLAN 100 tag on the WAN it drops after exactly 5 minutes to about 100-115 Mbps.
Very easy to reproduce, it takes 5 minutes everytime.
Can anyone tell me if there is anything specific happening 5 minutes after saving an interface?
Saving and applying an interface will somehow reset it and it has full speed again 946/947 for the whole of 5 minutes.
Traffic through my VPN does not get limited.
I have no Shaper active.
I have assigned and enabled the physical interface that the VLAN is tagged on.
Pages1
