Show Posts
1
22.1 Legacy Series / Unable to make changes after upgrade to 22.1
« on: May 10, 2022, 03:05:46 pm »
So I upgraded from 21.7.8 to 22.1 tonight. After the upgrade I wanted to log in to the CLI via SSH, but I keep SSH disabled and only enable it as needed. When I go to the System -> Settings -> Administration page, the "Save" button at the bottom is grayed out. No matter what I do on that page, I cannot save. I tried both with "root" and with my secondary admin account. I also have the same issue on the System -> Settings -> General page, so I cannot change my theme, DNS, or hostname (not that I'm looking to, but its not available if I need to). I can enable and disable firewall rules, but I tried adding a new one and I have the same issue on the new firewall rule configuration page, the "Save" button at the bottom is grayed out and not responding to clicks.
Is there anything I can do to fix this so that I can make changes again? Or am I going to have to roll back?
(FYI - Luckily I keep Serial enabled, so I was able to access the CLI that way and take care of things. My issue is the inability to save changes in the GUI)
คาสิโนออนไลน์ขั้นต่ำ5บาท
Is there anything I can do to fix this so that I can make changes again? Or am I going to have to roll back?
(FYI - Luckily I keep Serial enabled, so I was able to access the CLI that way and take care of things. My issue is the inability to save changes in the GUI)
คาสิโนออนไลน์ขั้นต่ำ5บาท