Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - chrismccracken

#1
Quote from: skywalker007 on March 10, 2022, 08:02:01 PM
Why wouldn't you not run it on the LAN Interface like recommended?

I have not seen a recommendation in any of the docs I've read so far about which interface to run it on. Every IDS I've used in the past binds to the WAN to get proper pre-filtering threat intel. I'll test it out with LAN, but that seems backwards  ???
#2
Zenarmor (Sensei) / Re: PPPoEeeeeeeee
March 10, 2022, 07:37:00 PM
Any updates here? I have a new OPNsense install (and Zenarmor was one of the major reasons I chose OPNsense) and just ran into this product gap during initial config.  :-\
#3
I have installed zenarmor on a new OPNsense 22.1 installation, and am running into a snag with the initial config wizard. My WAN interface does not show up in the Available interfaces box. The interface type is a pppoe running on a VLAN in an Intel ix interface. The unassigned VLAN subinterface does show up, but using that interface won't work properly since the WAN traffic is encapsulated in the pppoe tunnel on it. This seems to be a blocker for me, can anyone help?

**edit to add**
I've since found another post indicating that Sensei does not currently support pppoe interfaces.. Disappointed :(
(also, why is there no delete button for this reply?)