Messages

Hello,
Can someone give me some hints to compile a build for Compute Module 4?
Because Makefile give me some errors, ex:

Makefile:43: *** missing separator.  Stop.
Makefile:61: *** recipe commences before first target.  Stop.

Is FreeBSD mandatory to compile or Debian can be used too?

Many thanks!

Edit: disregard previous message, I have installed a Freebsd VM and compiling seems to work better now :)

I can confirm that the 22.1 image made by YRZR works with DFrobot carrier board with CM4 with 8GB Ram. Unfortunately the performance is only around 300Mb/s on 1Gb connection. Maybe some tuning needed to get better results. The cpu was only at 40% during downloads. Has anyone got better performance?

Thank you very much, I will take a look on this ;-)
Edit: testing cannot continue as I cannot boot on CM4 + DFRobot Mini router board :(

Dear all,

Currently, I have a CM4 (with 4GB RAM and 8GB eMMC and no Wifi) and the DFRobot IoT Router Carrier Board (https://www.dfrobot.com/product-2242.html).

I am interested to compile an OPNsense build for this hardware but I am a little bit lost about it's potential compatibility.

Can someone confirm me that's this will be good or not?

Many thanks in advance!