Messages

[LAN (em0): 192.168.1.253.130/24WAN (em1): 192.168.0.100/24]

He seguido las instrucciones para instalar OPNsense 21.1 en un VMWare 16 siguiendo las instrucciones que dan en este video https://www.youtube.com/watch?v=nJcx_WhbF0M.
Tengo configurada la VM pero la configuracion de red debe estar mal hecha ya que no consigo hacer pings a la LAN o a internet.
Mi conexion es una IP dinamica de Orange. Mi LAN esta en el rango 192.168.1.0/25. Mi router es el 192.168.1.1.
La tarjeta de red 1 de vmware es Bridge
La tarjeta de red 1 de vmware es NAT

La configuracion de OPNsense me da esto:
LAN (em0): 192.168.1.253.130/24
WAN (em1): 192.168.0.100/24

Alguna idea de lo que estoy haciendo mal?
Gracias

Hi,
I do not know if this is the right forum...
I am trying to improve my LAN and to separate LAN from WAN to install OPNsense. Righ now I have this configuration. Now I have everything coming form WAN going through a router (ER-6P)>>>Switch (USW-16-POE)>> all devices in LAN (PC, NAS, Cameras, etc.) in the same IP range 192.168.1.0 /24. This is working fine.

However, I was hit recently by a ransomware. After looking at the possible solutions to improve my network I have considered to install OPNsense in a miniPC. My undestanding is that I need to separate the WAN from the LAN and send all the traffic from the ER-6P to OPNsense first and then back to the switch to be distributed filtered to LAN. Therefore all traffic from router should go to OPNsense and for this it looks like I need a second dedicated network card to send the filtered traffic back to switch and the switch will serve all traffic to the LAN when it has been filtered by OPNsense.

However, I have 3 ETH unused ports in my router. I would like to ask if I could use an empty port to do the same. If this is the case I would appreciate a link on how to configure this. I have attached an image of my actual network.
Thanks