Messages

Hello.  Beginner network novice.  I currently am running OPNsense 24.7.7 on a Dell Optiplex 9020 and a 4 Port i350 1Gbps adapter.  I've setup 1 port as the WAN and the other 3 ports in a Bridged configuration.  In those 3 ports I have Unifi Switches that go to different areas of the house.  I have a unifi AP in 2 different switches.  Basic setup so everything works.  I haven't had an issue.  Now I want to setup WiFi networks for IoT devices and a separate Guest WiFi network and a Camera Network.  I'm trying to first setup the Guest WiFi network.  I can connect to the Guest WiFi but it cannot get Internet traffic.  I'm not sure what I'm doing even after reading some guides I found online.  What I think is the issue is the VLAN Parent only sees the individual interfaces but not the Bridged Interface but I'm not sure. Any assistance would be greatly appreciated.

Thank you.

Sorry I know this is an old thread but I'm curious.  I have an HP t730 with an i350T4.  8GB or RAM and a 32GB Drive.  When I use IPS and IDS out of box and enable all I usually get half my full bandwidth.  I have Verizon FiOS at Gig and RCN Gig service at another location.  Same exact t730s.  If I disable IDS/IPS I can get near full line speed.  I'm not strong in the Networking dept but I was hoping that the t730 would give me full line speed with IDS/IPS on.  I then configured the MTU and MSS to 1500 hoping I'd see a miracle.  Nada.  lol  My CPU spikes every once in a while.  RAM usage is usually low.  No clue what I did wrong.