Menu

Show posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Show posts Menu

Messages - thellama

#1
21.1 Legacy Series / Re: CenturyLink fiber (PPPoE setup)
February 25, 2021, 07:25:08 PM
So, just figured it out.
Anyone that encounters this, make sure your PPP interface is set to the VLAN201 interface, not the physical interface.
#2
21.1 Legacy Series / CenturyLink fiber (PPPoE setup)
February 25, 2021, 06:56:50 PM
Hi all,
I just got a gigabit fiber line installed, I have been trying to get the PPPoE connection setup in OPN but I am not having any luck.
I've followed this guide, accounting for the differences between pf and OPN: https://bidetly.io/2020/03/20/centurylink-fiber-on-pfsense/

But all I see on the PPP diags:
2021-02-25T10:54:45 ppp[57901] [opt1_link0] PPPoE: Connecting to ''
2021-02-25T10:54:45 ppp[57901] [opt1_link0] Link: reconnection attempt 4678
2021-02-25T10:54:43 ppp[57901] [opt1_link0] Link: reconnection attempt 4678 in 2 seconds
2021-02-25T10:54:43 ppp[57901] [opt1_link0] LCP: Down event
2021-02-25T10:54:43 ppp[57901] [opt1_link0] Link: DOWN event
2021-02-25T10:54:43 ppp[57901] [opt1_link0] PPPoE connection timeout after 9 seconds
2021-02-25T10:54:34 ppp[57901] [opt1_link0] PPPoE: Connecting to ''
2021-02-25T10:54:34 ppp[57901] [opt1_link0] Link: reconnection attempt 4677
2021-02-25T10:54:31 ppp[57901] [opt1_link0] Link: reconnection attempt 4677 in 3 seconds
2021-02-25T10:54:31 ppp[57901] [opt1_link0] LCP: Down event
2021-02-25T10:54:31 ppp[57901] [opt1_link0] Link: DOWN event
2021-02-25T10:54:31 ppp[57901] [opt1_link0] PPPoE connection timeout after 9 seconds
2021-02-25T10:54:22 ppp[57901] [opt1_link0] PPPoE: Connecting to ''
2021-02-25T10:54:22 ppp[57901] [opt1_link0] Link: reconnection attempt 4676
2021-02-25T10:54:21 ppp[57901] [opt1_link0] Link: reconnection attempt 4676 in 1 seconds
2021-02-25T10:54:21 ppp[57901] [opt1_link0] LCP: Down event


Is there somewhere that would provide more info from logs or has anyone got this set up successfully?