Messages

Unfortunately I got the version with the case and I'm not sure how to open it to access the uart serial console.

On the bottom of the case are 4 rubber pads. Remove those and you'll have access to 4 screws to take of the bottom, then there's two screws on the board. When you have all the screws out you'll have to gently slide the board so that it's pressed all the way up against the side of the case that the ethernet ports are on and then it should come out.

Not sure what was going on but I finally got the 4GB running with the link above. It is using the default of 192.168.11.1:80 and dhcpv4 is disabled (that may have been why I couldn't get in). The only light that comes on is the power light.

However, I can't login as it doesn't use the default or any of the standard combos I could think of (root/root, root/password, root/opnsense, admin/admin, etc). Does anyone know what the log in is?

edit: nevermind, turns out there's something else on my network at 192.168.11.1:80, which is very od considering my network uses 10.0.0.0/24...

Hi, I've flashed the 4gb version from https://mirror.fkardame.com/Linux/Images/FriendlyArm/NanoPi%20R4s/ on a Nanopi r4s 4gb, but I don't believe it runs.

I'm having the same problem. Tried it with another image @tsgan sent me and it also didn't boot. Connected via serial and there's nothing.

What is needed to build crochet for this? Do I just compile a generic and set it up at boot via serial or do I need to build some files for it? If custom files are needed, it'd be very helpful to get what's been used for the other model and this one so I can make minor changes rather than build the entire thing as this isn't really something I have experience with.

Any way to get the code for that? Tried running the compiled img and it doesn't boot.