Messages

In the commercial analog of OPNsense, there is a setting where in the local database administrator can set to the user an a specific ip address. This setting allows the user to automatically connect to the proxy without entering a username and password.

Hello.

Version of OPNsense - 20.7.3

I read the setup instructions - Documentaion/wiki & forum.

But I can't find an answer to my question.

Can the firewall perform automatic authentication by ip address?

For example: set the ip address to a specific username and then pass verification in the proxy.

Thank you.
If a username with a capital letter - authentication fails.
If a username with all small letters - authentication pass.

I have a question about the correct Web Proxy configuration.

Version of OPNsense - 20.7.3

I read the setup instructions - Documentaion/wiki

My workflow for setting up
1. Services-Web Proxy-Administration-General Proxy Settings: Enable proxy check.
2. Services-Web Proxy-Administration-Authentication settings: Authentication Method - Local Database.
3. System-Access-Groups: created a new group.
4. System-Access-Users: added two new users.
5. System-Access-Groups: added users to a new group.
6. System-Access-Tester: both users test passed.
7. Firewall-Rules-LAN: added two rules to block http/https bypass.
8. Save settings and restart services.
9. Configured the computer to use a proxy, correct ip-address and port number.

When connecting computer to the Internet via a proxy, with correct username & password - I don't pass verification & don't get access to the Internet.

Please help me. What I'm doing wrong?

Hello.

I have a question about the correct Web Proxy configuration.

Version of OPNsense - 20.7.3

I read the setup instructions - Documentaion/wiki

My workflow for setting up
1. Services-Web Proxy-Administration-General Proxy Settings: Enable proxy check.
2. Services-Web Proxy-Administration-Authentication settings: Authentication Method - Local Database.
3. System-Access-Groups: created a new group.
4. System-Access-Users: added two new users.
5. System-Access-Groups: added users to a new group.
6. System-Access-Tester: both users test passed.
7. Firewall-Rules-LAN: added two rules to block http/https bypass.
8. Save settings and restart services.
9. Configured the computer to use a proxy, correct ip-address and port number.

When connecting computer to the Internet via a proxy, with correct username & password - I don't pass verification & don't get access to the Internet.

Please help me. What I'm doing wrong?