"
You were right, i added default route instead gateway on my AP and can't connect.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
20.7 Legacy Series / Re: Firewall rule problem
October 21, 2020, 10:05:15 PM
LAN net is default internal network from OPNsense
#3
20.7 Legacy Series / Re: Firewall rule problem
October 21, 2020, 08:49:25 PM
This is automatic rule in floating.
#4
20.7 Legacy Series / Re: Firewall rule problem
October 21, 2020, 08:28:03 PM
The Deny rule is from floating, but it should not be aplied as it's not set to first matc unlike my lan rule.
#5
20.7 Legacy Series / Firewall rule problem
October 21, 2020, 07:54:31 PM
I have this setup, i can ping hosts on subnet but default deny rule is aplied when doing anything else and not my created lan rule.
#7
20.7 Legacy Series / Re: DNS_PROBE_FINISHED_NXDOMAIN error
October 10, 2020, 09:18:20 PM
Maybe one of them lost internet connection.
Try to manually switch off internet and see if this repeats.
Try to manually switch off internet and see if this repeats.
#8
20.7 Legacy Series / NAT Outbound and Port Forward
October 10, 2020, 01:43:09 PM
I have this setup where i connect OPNsense to OpenVPN and then redistribute the connection to OVH_LAN.
When i enable outbound the web server have accessto the internet via 55.55.55.5 IP
When i disable outbound and enable port forward, web server is accesible via 55.55.55.5 IP
But when i enable both outbound and port forward only the port forward is working.
How can i port forward and use outbound?
When i enable outbound the web server have accessto the internet via 55.55.55.5 IP
When i disable outbound and enable port forward, web server is accesible via 55.55.55.5 IP
But when i enable both outbound and port forward only the port forward is working.
How can i port forward and use outbound?
Pages1
