"
figured it out. it was not opnsense causing the issue. my eap245 tp link had my wireless network guest mode enabled, causing the issue.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
20.1 Legacy Series / [solved] accessing 192.168.1.1 only works when wired
October 01, 2020, 07:21:26 AM #2
20.1 Legacy Series / Re: accessing 192.168.1.1 only works when wired
October 01, 2020, 06:09:28 AM
yep.
LAN 192.168.1.39 cc:32:e5:4c:d4:1a
EAP245-CC-32-E5-4C-D4-1A 2020/10/01 04:05:37 UTC 2020/10/01 06:05:37 UTC active
There is a DHCP on the WAN but if I turn that off, then I loose internet
LAN 192.168.1.39 cc:32:e5:4c:d4:1a
EAP245-CC-32-E5-4C-D4-1A 2020/10/01 04:05:37 UTC 2020/10/01 06:05:37 UTC active
There is a DHCP on the WAN but if I turn that off, then I loose internet
#3
20.1 Legacy Series / accessing 192.168.1.1 only works when wired
September 25, 2020, 06:35:51 AM
I can get to the webui using a wired connection, but it never resolves when I do it over wireless. What setting do I need to set to enable that. Internet works fine wired or wireless; I just can not access IPs wirelessly that are on my network from devices. thanks!
Pages1
