"
I am interest ed in working with you. Please tell me what you need
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
20.7 Legacy Series / Re: Would anyone want to help me with assessing my ip blocklist?
October 03, 2020, 03:00:56 AM #2
20.7 Legacy Series / Re: Block subnets
October 02, 2020, 02:20:20 AM
This is interesting, I have the opposite. Lan1 routes to wan and works as you would expect. The opt1 interface can route route but does not have any ability to see lan1. The firewall is set to default on both networks lan1 and opt1, only difference opt1 base a gateway definition to wan. Not sure how this happened since I did a fresh install 20.7.1 and upgraded to 20.7.3 before I started working configurations.
#3
20.7 Legacy Series / Re: SSH not working from LAN.
September 23, 2020, 03:06:54 AM
For this particular instance chemlun was correct:
System -> Settings -> Administration -> Secure Shell is enabled and LAN is in the "Listen Interfaces"?
Thanks everyone for helping. On to the next configuration issue ....
System -> Settings -> Administration -> Secure Shell is enabled and LAN is in the "Listen Interfaces"?
Thanks everyone for helping. On to the next configuration issue ....
#4
20.7 Legacy Series / Re: SSH not working from LAN.
September 22, 2020, 01:42:35 AM
interface/settings show CRC, LSO, and LRO are all disabled. I am currently using Putty Version 0.60. If there is anything else I can do, please let me know.
#5
20.7 Legacy Series / SSH not working from LAN.
September 18, 2020, 12:33:33 AM
I have a new installation with 20.7. Everything is setup with default settings. When attempting to execute ssh to opnsense, the connection fails. ssh_exchange_identification: Connection closed by remote host. Both client and opnsense are on the same subnet. LAN is functioning well with firewall access to WAN (Spectrum). OPT1 (2nd Subnet has not been tested yet.)
Pages1
