"
Thanks phoenix, but I didn't have IDS running, in fact there was nothing more than bare bone opnsense install. Any way i did a rebuild and restored my configuration and then applied the update again. So all good now. I wonder what made the page fault error.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#2
20.7 Legacy Series / Boot loop after the latest update
September 03, 2020, 04:53:08 PM
Hi all,
Noob here. Just updated my opnsense to the latest system update and it went into a boot loop. But I was able to get to the crash report screen and copied it, and at the end of the report i can see
"Fatal trap 12: page fault while in kernel mode"
I backed the config just before patching so I may be ok. Any ideas would be appreciated if I don't have to rebuild it.
Noob here. Just updated my opnsense to the latest system update and it went into a boot loop. But I was able to get to the crash report screen and copied it, and at the end of the report i can see
"Fatal trap 12: page fault while in kernel mode"
I backed the config just before patching so I may be ok. Any ideas would be appreciated if I don't have to rebuild it.
Pages1
