Messages

Would you please share your Outbond NAT and Rules screenshot. and which DNS your using.

i am also facing same issue. i created the VLAN and try to route the traffic but its not working. I wan to route my all VLAN30 traffic to VPN.

I setup the VLAN and Private OpenVPN Client to VPN Provider on my Opnsense. i fallow the guides to route the traffic but still i am unable to route my VLAN traffic to Private VPN connection. attached is my Firewall Config. appreciate any help.
Any assistance will be appreciated.

Try to remove GW_LAN and make it all (*) under gateway.

Post your LAN firewall settings. Please make sure not using custom gateway.

it was firewall but there was no block rule. i just added custom gateway on my LAN Firewall
which cause the problem, I remove it and then I able to reach it ntopng web interface.

Thanks for your help to hint it.

Installed the ntopng and redis from plugins both are running but unable to access the webpage using http://<IP>:3000. Reinstalled the several times but still same issue.

root@opnsense:~ # service redis status
redis is running as pid 52830.
root@opnsense:~ # service ntopng status
ntopng is running as pid 86522.

root@opnsense:~ # sockstat | grep -i ntopng
ntopng   ntopng     86522 1  udp4   192.168.2.1:62447     *:*
ntopng   ntopng     86522 3  udp4   *:*                   *:*
ntopng   ntopng     86522 6  tcp4   127.0.0.1:45887       127.0.0.1:6379
ntopng   ntopng     86522 7  tcp4   127.0.0.1:26751       127.0.0.1:6379
ntopng   ntopng     86522 8  udp4   *:*                   *:*
ntopng   ntopng     86522 9  udp4   *:*                   *:*
ntopng   ntopng     86522 11 tcp4   *:3000                *:*
ntopng   ntopng     86522 12 dgram  -> /var/run/logpriv

any idea, appreciate the help.