Messages

1

20.1 Legacy Series / Re: Stumped with firewall rules

« on: May 21, 2020, 05:54:58 pm »

I'm stupid, I wrote this when I was really tired.

This IP shouldn't be allowed access to the server since the 10.x.x.x network should only go to my raspberrypi. Then the raspberrypi reaches out to 192.168.5.26. So there's no issue at all. Wish I could delete this thread!

2

20.1 Legacy Series / Stumped with firewall rules

« on: May 21, 2020, 07:11:38 am »

So I'm trying to allow my Wireguard client (10.0.0.2) to communicate with a host on my internal LAN (192.168.5.26:443). I swear I've set the rules up correctly but somehow it keeps getting blocked by the default rule. Like it's skipping over the rule I made to allow it, and I don't understand why. I've even tried setting the ports statically in the rule but it STILL drops it at the default deny rule.

I know I must be missing something stupid here.. Any ideas? The IP addresses I've assigned to Wireguard are set statically on the client, could that be it? Also, I am not using Wireguard built into OPNsense, I'm using it on a Pi attached to my internal LAN.