"
Got it working. I had set the gateway for the firewall rule on the WAN2 interface to the WAN2 gateway. Setting it back to default solved it.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
20.1 Legacy Series / Re: Getting Policy-Based Routing working for Incoming Connections with Multiple WANs
April 14, 2020, 02:57:30 PM #2
20.1 Legacy Series / Getting Policy-Based Routing working for Incoming Connections with Multiple WANs
April 13, 2020, 05:39:58 PM
Hi!
I'm running OPNsense 20.1.4-amd64 on a PCEngines ACU box with three physical interfaces. I have two WANs defined in a migration period so I need my services/servers to be accessible on both WANs for a period while we migrate from the old to new the ISP. Currently I'm able to see incoming traffic, and the firewall also accepts it, but I never see any return traffic from my OPNSense device.
I have multiple gateways under System - Gateways - Single and both are in the state "Online". Under the firewall rules I have added explicit rules to match the incoming traffic on the WAN2 interface with the gateway of the new ISP configured - just to begin with I have added a pass rule for ICMP traffic. The Destination is set to "WAN2 address". But it still doesn't seem to be working.
Any ideas?
I'm running OPNsense 20.1.4-amd64 on a PCEngines ACU box with three physical interfaces. I have two WANs defined in a migration period so I need my services/servers to be accessible on both WANs for a period while we migrate from the old to new the ISP. Currently I'm able to see incoming traffic, and the firewall also accepts it, but I never see any return traffic from my OPNSense device.
I have multiple gateways under System - Gateways - Single and both are in the state "Online". Under the firewall rules I have added explicit rules to match the incoming traffic on the WAN2 interface with the gateway of the new ISP configured - just to begin with I have added a pass rule for ICMP traffic. The Destination is set to "WAN2 address". But it still doesn't seem to be working.
Any ideas?
Pages1
