"
Some are longer -- It was upwards of a minute at times. I am using the standard Mullvad recommended DNS server and whenever I use the regular Wireguard client I do not have this issue. Same server on the local desktop client as I setup on OPNSense.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Pages1
#1
20.1 Legacy Series / Re: Mullvad Wireguard Setup - Constant Disconnection/Disruptions
March 18, 2020, 01:40:18 AM #2
20.1 Legacy Series / Mullvad Wireguard Setup - Constant Disconnection/Disruptions
March 17, 2020, 03:14:04 AM
I followed the various guides and documentation in order to setup a Wireguard (Mullvad) tunnel that pushes all traffic through it. However I am now getting constant disconnects/disruptions and having web pages fail to load for 10-30 sec and eventually the connection seems to re-establish and work again.
Steps I used:
1. Setup Wireguard Local / Endpoint connection / Interface (no IP)
2. NAT Rule (Hybrid mode) to push all Wireguard interface traffic from local LAN through it
Everything was based on the 2-3 guides/documentation I found and it worked pretty much immediately but the disconnections and disruptions started right away and have persisted for a few hours now.
I'm wondering if anyone else has experienced this and if there is anything obvious that I should look at to fix it.
Thanks in advance.
Steps I used:
1. Setup Wireguard Local / Endpoint connection / Interface (no IP)
2. NAT Rule (Hybrid mode) to push all Wireguard interface traffic from local LAN through it
Everything was based on the 2-3 guides/documentation I found and it worked pretty much immediately but the disconnections and disruptions started right away and have persisted for a few hours now.
I'm wondering if anyone else has experienced this and if there is anything obvious that I should look at to fix it.
Thanks in advance.
Pages1
