Messages

Thank you for both your answers.

Here is what I did, but unfortunately that changed nothing:
- I removed the explicit DNS settings in WireGuard configuration, ran a few tests, then disabled completely WireGuard, ran tests again: nothing changed. Package updates are still horribly slow to check, HAProxy changes can't be saved (but HAProxy service works fine in itself), DPinger doesn't start automatically.
- I put down IPv6 gateway, disabled IPv6 completely in OPNsense, ensured IPv4 connectivity is still maintained, rebooted, then ran the same tests: nothing changed, same problems for HAProxy and package updates.

Checking the logs, I see nothing useful :
2023-02-08T22:09:49   Error   configd.py   Timeout (120) executing : haproxy configtest   
2023-02-08T22:08:29   Error   configd.py   Timeout (120) executing : firmware remote
I can see no warning/error in Unbound logs.
Should I check another log, or run a specific test?

So far, I'm not solving much, and I'll need to change a few things in HAProxy very soon.
I might be trying to reinstall completely OPNsense and restore a backup config file, but I'd like to keep that intervention as a last resort.

Hello,

I updated to 21.3_6 today (from 22.7.11), and unfortunately ran into some issues :

First one: update check will throw a fetch timeout message, changelog truncated, then the process stays stuck minutes and minutes, seems to check for package updates, but will not display the usual pop-up indicating that there's no update. The wheel in the update tabs won't stop turning.
Also, the plugins tab will mark every plugin I have installed as "orphaned". I can't see any available plugin either.

Second one: I am unable to save any changes to my HAProxy service.
"Test Syntax" button will show the loading wheel turning forever. No pop-up telling me that my changes are OK or need to be corrected.
Same for the "Apply" button: the loading wheel turns forever, and the changes will never be applied.

Third one: after a reboot, the dpinger service on my IPv6 gateway will never start. I have to do so manually.
(The dpinger on the IPv4 gateway has no problem starting)

Any help solving these issues would be very appreciated!
Thanks in advance!

Hello,
I'm a long time user, but never used some features within Zenarmor.

I'm trying to send regular reports to my e-mail address. However, there's a problem when I set things up:
My SMTP server needs a known "from-address", but Zenarmor seems to give a blank one, even though I filled the "Send mail from" option.
I tried using SMTP and SMTPS with and without TLS certificate check: same results.
The mail server is configured without authentication when queries come from known IP addresses: works fine from Monit within OPNsense, Nextcloud server, and so on.

(Please see attached screenshots: my configuration tab, the error message from Zenarmor side, and the SMTP logs from the mail server side)

Is there something I am missing that allows Zenarmor to fill correctly the from-address when using SMTP services?

Any hint would be much appreciated!
In advance, thanks to anyone who can help me!