Messages

This does not speak for my deductive skills... :o The presence of

Code Select Expand

/boot/dtb/overlays would have told me that...

Unfortunately, a

Code Select Expand

if_atlantic.ko is nowhere to be seen.
There is a freeBSD driver available on the aquantia Website. (Or at least a zip package with a makefile) How can I add it to the VM / the install ISO?

Thank you for your patience! Very kind of you!

Thank you for you assistance!

The paths are:

Code Select Expand

/boot/kernel
/boot/modules
/boot/dtb
/boot/dtb/overlays

Have can I read these files? Nano is not installed and vi just returned garbage. :/

Sorry, I never used a *BSD based OS...

Thank you very much @hbc for your reply. The command returns:

Code Select Expand

kldload: can't load if_atlantic.ko: No such file or directoy

How can I insert the driver at this point?

Thank you very much in advance.

Hi there

I'm trying to setup OPNsense in a KVM VM under Arch Linux. I would like to use the firewall for the host and other VMs. So internally I'd like to use vswitches. However, on the WAN  side I'd like to use a physical NIC. But my passed-through Aquantia AQC107 won't show up. I installed OPNsense, but haven't done any configuration yet. When assigning interfaces I only see a vNIC.

Is this a known issue due to missing drivers or should I look somewhere else?

Any hints that could resolve this issue are highly appreciated. :)
Thank you very much in advance!

Hi there
I'm planning a new rig on which I'd like to run OPNsense 24/7 in a VM. I plan to use unRAID as a hypervisor, which allows to pass-through PCI devices. So I'll probably pass through the NIC directly to OPNsense. Now my question is which network card I should install on the WAN side, where I have a 10 GBit/s connection (RJ45, Cat6). Internally I will use vNICs to the other VMs and 1 GBit NICs I already own.

A single 10 GBit port is enough.
Thank you very much for your recommendations!