Messages

I had 1 on BOTH nodes. now i iave 1 on master and 101 on backup for ll of my Virtual IPs and all works well. in my case this was the root cause.
i use Failver with virtual IPs, CARP, VLANs and LAGG, so i did think this was the issue. turned out it wasn't. lucky me, because there s no real solutions as it seems if  you have problems with LAGG and CARP. 

Meanwhile the problem has been solved.
Turns out it was a mistake on my config, the adskew settings were not properly set.
Besides, i found a lot of blofposts and community posts regardinf the topic Failover with CARP, VLAN and LLAG.
Maybe this is woth investigating if you still have problems with virtual IP and failover.

Hello opnsense community,

i have a 2 node opnsense HA setup with 10 virtual IPs (CARP).
Node 1 is the Master, node 2 the Backup node in the HA setup.

When node 1 (MAster) is switched off , all virtual IPs are moved to the backup node, works just fine.
When node 1 is switched on again and becoming master, not all of the virtual IPs are moving over to the node 1, sometimes 2 of them stay on the former master, now backup, node 2. Could this be due to still open connections still on node 2?

Is there any way to kinda debug this? Anyone know this behavior and could point me in the direction where to search for the root cause?

Hallo,

ich nutze Opnsense latest version als virtuelle Maschine auf TEST und PRODUKTION.
Normalerweise sollten die sich bis auf die IPs gleichen, allerdings sehe ich auf einer OpnSense in denFirewall Rules die Punkte " Wende die Aktion sofort bei einem Treffer an." und "Richtung", auf der anderen OpnSense werden die optionen mir erst gar nicht angezeigt. Kabn mir jemand sagen, welche option ich da u.U. verstellt habe, um diese Punkte im Firewall Rule Setup ein- bzw. auszublenden ?

Danke und Gruß