"
The OS sees em2 and it is connected to the network with link lights on the OPNsense system and the switch. In fact I believe I saw a screen during the installation that indicated em2 link state was up. When I try to configure an IP address for em2 it comes back with the message link state down. Any ideas? I previously had pfSense running on this system and em2 was working fine.
It was not the installation screen but the boot up screen that indicates em0,em1,em2 link state up! I am unable to assign an IP address to em2 as message back says no link state!
It was not the installation screen but the boot up screen that indicates em0,em1,em2 link state up! I am unable to assign an IP address to em2 as message back says no link state!
