Messages

Thanks for providing those steps to update. I've now got my APU2 running 4.9.0.2 and OPNsense is 19.1.2.

However the Thermal Sensors are still not showing until after I go into the shell and run "kldload amdtemp"

Where could I find a log of when it should try to load this module?

Hi, I'm brand new to OPNsense (installed it yesterday) so this might just be a config error on my part, but I noticed the Thermal Sensors on the Dashboard were not displaying any data. I'm running OPNsense on an APU2D4.

I found an old forum post (https://forum.opnsense.org/index.php?topic=4094.0) and followed the steps in there. After running the command "kldload amdtemp" in the shell, the temperature was correctly showing in the Dashboard. Of course this does not persist after a reboot.

Any suggestions for a permanent fix?