Messages

Hi Peter,

with the single firewall, after uninstalling the ntopng components and reinstalling them, I was able to get ntopng to work without errors.
I didn't succeed with the other two firewalls, although the hardware and software are almost the same.
I got the impression that ntopng is not well maintained. There is also very different documentation for the installation on OPNsense. I think I took notes on installing on the single firewall. If you want, I can send them to you.

Regards
Morn

I have three firewalls running. Two work in CARP mode and one at a different location.
Before the updates/upgrade there were no problems with ntopng. After the updates/upgrade from v21.7.7 to v22.1.2, the CPU in all three firewalls hits the limit.
top
last pid: 22632;  load averages:  3.24,  1.23,  0.62    up 9+16:15:58  13:55:31
40 processes:  1 running, 39 sleeping
CPU: 71.3% user,  0.0% nice,  1.2% system,  0.0% interrupt, 27.5% idle
Mem: 137M Active, 1024M Inact, 777M Wired, 384M Buf, 2006M Free
Swap: 8192M Total, 8192M Free
PID USERNAME    THR PRI NICE   SIZE    RES STATE    C   TIME    WCPU COMMAND
96583 ntopng       35  20    0   259M   179M nanslp   2   2:57 286.97% ntopng

I disabled ntopng and everything runs smoothly. Should I uninstall and reinstall ntopng?
Thanks for any help with this.

Ohne zutun werden seit heute früh wieder Daten aufgezeichnet.

Morn

Servus Leute,

vor gut 2 Wochen habe ich erstmals OPNsense auf ein APU2C4 installiert (Stand v18.7.3).
Seit ein paar Tagen (´18 d269) erscheinen keine Daten mehr unter "System/Memory".

Wie kann man das reparieren?

Danke für die Unterstützung.

Morn